The battery also maintained 4.1v while driving a DC motor (from an old floppy drive). The battery voltage rose to 4.2v (expected and good). I connected the watch & battery to a PC to charge and later to a charger. The battery presented a 2.8v charge on my DMM. If it did then do share this article with a friend or two on social media.Ī friend asked me to look at a DZ09 watch given to him. So guys do share your experience below and tell me if this worked for you as it did in my case. Final ThoughtsĪs you can see guys this was a case of the battery not holding in place after the back cover of this Smartwatch was placed on which can be very annoying as you can see. Power your Smartwatch on as you normally do and it should power up easily unlike before. Now the battery will be pushed into place perfectly with the paper stand-off that you create and its no longer loose and now making a perfect connection with the terminals and not sliding or falling out of place due to the gap that was once between the battery and the cover.Ĥ.
This will act as a stand-off so the battery can make proper connection with its connectors to power the watch once the cover is put back on.Also a small piece of cotton can also do the trick about the size as on a q-tip too.ģ.Now snap the back on of the Smartwatch once more. Next cut a piece of paper that about 2-3 sheets thick to place in the back of the watch on top of the battery.
It advice that you at least try this fix a few times before giving up.ġ.Remove the back cover of your Smartwatch.Ģ. Please note that this fix only works in some cases and not all.
GT08 WATCH FACES INSTALL HOW TO
How to fix the Not turning on Issue with these cheap Smartwatches? This issue affects Smartwatches such as the GT08, DZ09, or U8 Smartwatch or devices of a similar design.This can happen to a new Smartwatch out of the box or it can happen to you after you have had the device for a while and it was working fine.
GT08 WATCH FACES INSTALL FULL
In most cases the cause of these watches not powering up or on is a manufacturing flaw where the battery pins or terminals are not making full connection with the battery as they should.In other words the battery does not fully sit flush in the back when the cover is on the watch and seeing your hands tend to be mobile and move around this will result in it moving out of the fixed position it needs to be in and thus no power to the device.įor things to work properly the battery needs to be a snug fit in its compartment making perfect contact and not rocking or sliding out of place. So much so that you may even consider throwing this device away thinking its no good. As described above cheap Smartwatches that are affected by this issue simply won’t turn on even after charging, pressing the power or sleep wake button or home button you simply wont get anything from your watch.
0 kommentar(er)
